So the help i need from you is "" is there any way that I CAN ONLY RUN THE FAN CONTROL MODULE DIRECTLY WITHOUT STARTING THE HWINFO APPLICATION SO THAT I CAN ADD THAT MODULE TO AUTO START WHICH WILL START ALONG WITH THE SYSTEM EVERYTIME THE SYSTEM STARTS with the preffered settings. Fan Control is not an official HWiNFO feature and there are currently only very few specific machines supported: - Alienware - all current models should be supported, but there are limitations based on model and fan control mode (EC support disabled/enabled) - DELL - many models supported, but fan control limited. This trick helped me hope it can help somebody else. even if the charger is unplugged, Now the fans continuously runs at 3000 rpm without caring if the the charger is plugged in or not. it does not return the speed of fan to automatic mode again. So i just selected manual fan speed and selected "set speed" only and ""i did not select 'apply and save' and closed the application hwinfo. Two of them report crazy temperatures over 100C which Ive learned indicates open circuit as in not in use. At the moment Ive just mixed them but no idea which fan can reduce any of them.
It would be nice to know which area of the motherboard they pertain too. but when i select apply and save the fan speed returns to automatic mode. I have 6 fans in total 3 at top AIO 2 on the side. i have set it to 3000 rpm because when the charger is plugged.the fan continuously runs on 3000 rpm when i select manual mode from fan control tab and set the fan speed and select "set speed" the fan speed increases. The issue with this notebook is only when the charger is plugged fan runs and when it is removed, fan stops.
0 kommentar(er)
